IANZ Accredited Test Methods
|
Air Resource Management is compliant with ISO/IEC 17025 General Requirements for the Competence of Testing and Calibration Laboratories Stationary Source Emissions (sampling)In accordance with American Society for Testing and Materials: ASTM D3154:00 Determination of gas flow data in stacks In accordance with Australian Standards: AS 4323.1 Selection of sampling positions AS 4323.2 Total particulate emissions from stationary sources In accordance with USEPA methods: |  | |||||||
Method 1 Sample and velocity traverses for stationary sources
Method 1A Sample and velocity traverses for stationary sources with small stacks or ducts
Method 2 Determination of stack gas velocity and flowrate (Type S Pitot Tube)
Method 3 Determination of oxygen and carbon dioxide emissions from stationary sources
Method 4 Determination of moisture content in stack gases
Method 5 Determination of particulate matter from stationary sources
Method 6 Determination of sulphur dioxide emissions from stationary sources Inc analysis
Method 7C Determination of nitrogen oxide emissions from stationary sources
Method 8 Determination of sulphuric acid mist and sulphur dioxide emissions from stationary sources
Method 11 Determination of hydrogen sulphide content of fuel gas streams in petroleum refineries
Method 13A Determination of total fluoride from stationary sources (SPANDNZ Zirconium Lake)
Method 13B Determination of total fluoride from stationary sources (Specific Ion Electrode)
Method 17 Determination of particulate matter from stationary sources (Instack Filter)
Method 18 Measurements of gaseous organic compounds emissions
Method 26 Determination of hydrogen halides and halogen emissions (non isokinetic)
Method 26A Determination of hydrogen halides and halogen emissions
Method 29 Determination of metal emissions from stationary sources
Method 0011 aldehyde emissions from stationary sources
Method 201A Determination of PM10 emissions (constant sampling rate procedure)
Method 202 Determination of condensable particulate emissions from stationary sources
Method CTM-027 Procedure for collection and analysis of ammonia in stationary sources
Method CTM-031 Screening method for methylene diphenyl diisocyanate
Method CTM-036 Method for measurement of isocyanate compounds in stack emissions
Method OTM-027 Determination of PM10 and PM2.5 emissions (constant sampling rate procedure)
Supersedes
Method CTM-040 Determination of PM10 and PM2.5 emissions (constant sampling rate procedure)
In accordance with National Council for Air and Stream Improvement:
NCASI CI/WP-98.01 Chilled impinger method for use at wood products mills to measure formaldehyde, methanol and phenol Inc formaldehyde analysis
In accordance with British Standards:
BS EN 13649:2002 Determination of gaseous organic compounds (VOC)
In accordance with Australian/New Zealand Standards:
AS/NZS 4323.3:2001 Determination of odour concentration by dynamic olfactometry
Sampling and Analysis
AS4323.1 Selection of sampling positions
AS4323.2 Total particulate emissions from stationary sources
Method 5 Determination of particulate matter from stationary sources
Method 6 Determination of sulphur dioxide emissions from stationary sources
Method 17 Determination of particulate matter from stationary sources (Instack Filter)
Method 201A Determination of PM10 emissions (constant sampling rate procedure)
Method 202 Determination of condensable particulate emissions from stationary sources
Method OTM 27 Determination of PM10 and PM2.5 emissions from stationary sources (constant sampling rate procedure)
NCASI CI/WP-98.01 chilled impinger method for use at wood products mills to measure formaldehyde
Workplace air monitoring and vents (sampling)
In accordance with USEPA methods:
Method TO11A aldehyde monitoring of workplaces
Method TO17 volatile organic compounds in ambient air
|
IANZ Accredited
